Onicon F-2600 Manuale Utente Scaricare il pdf (Pagina 53)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-2600 & F-2700 Vortex Flow Meter Manual 02/15 - 0808-7 / 19204 Page 53

SECTION 3: OPERATING INSTRUCTIONS

After installing the vortex ow meter, you are ready to begin operation. The sections in this chapter

explain the display/keypad commands, meter start-up and programming. The meter is ready to operate

at start-up without any special programming. To enter parameters and system settings unique to your

operation, see the following pages for instructions on using the set-up menus.

3.1 FLOW METER DISPLAY/KEYPAD

The ow meter’s digital electronics allow you to set, adjust

and monitor system parameters and performance. A full range

of commands are available through the display/keypad. The

LCD display gives 2 x 16 characters for ow monitoring and

programming. The six push-buttons can be operated with the

enclosure cover removed. Or, the explosion proof cover can

remain in place and the keypad operated with a hand-held

magnet positioned at the side of the enclosure as shown in the

illustration at the left.

Figure 49. Flow Meter Display/Keypad

From the Run Mode, the ENTER key allows access

to the Set-up Menus (through a password screen).

Within the Set-up Menus (through a password

screen). Within the Set-up Menus, pressing ENTER

activates the current eld. To set new parameters,

press the ENTER key until an underline cursor

appears. Use the ⇑ ⇓ ⇐ ⇒ keys to select new

parameters. Press ENTER to continue. (If change

is not allowed, ENTER has no effect.) All outputs

are disabled when using the Set-up Menus.

The EXIT key is active within the Set-up Menus.

When using a Set-up Menu, EXIT returns you to

the Run Mode. If you are changing a parameter

and make a mistake, EXIT allows you to start over.

The ⇑ ⇓ ⇐ ⇒ keys advance through each screen

of the current menu. When changing a system

parameter, all ⇑ ⇓ ⇐ ⇒ keys are available to enter

new parameters.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 130 131

Nessun commento

Onicon F-2600 Manuale Utente Pagina 53