Onicon F-5200 Inline Manuale Utente Scaricare il pdf (Pagina 18)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-5200 Inline Thermal Mass Flow Meter Manual 05/14 - 0763-4 / 19476 Page 18

SECTION 5.0: TROUBLESHOOTING GUIDE

NOTE: Also refer to the START-UP AND COMMISSIONING GUIDE located on page 15.

REPORTED PROBLEM POSSIBLE SOLUTIONS

No signal • Verify that the meter is properly installed in the pipe.

• Verify that the ow direction arrow is pointing in the right direction.

• Verify supply voltage.

• Verify correct wiring to control system (see wiring diagram).

• Verify that there is ow in the pipe.

• Please contact ONICON for further assistance.

Reading is too high or

low

• Verify that the meter is properly installed in the pipe.

• Verify that the ow direction arrow is pointing in the right direction.

• Verify correct wiring to control system (see wiring diagram).

• Conrm that the control system is programmed for correct ow range

or pulse scale factor.

• Verify that the meter cable shield is connected to earth at the control

system. Lack of proper shielding can lead to excessive noise that can

affect the ow reading.

• Verify that the meter is connected to earth.

• Check for ground loop or offset voltage:

• Disconnect analog signal input from control system and measure

analog output directly from the ow meter.

• Reconnect signal input to control system and measure the analog

signal again. Any difference between these readings indicates a

potential ground loop or offset voltage.

• Meter is being used to measure ow of a different gas or gas mix than

the meter was specied and calibrated for.

• Please contact ONICON for further assistance.

Erratic readings • Conrm that the meter is connected to earth and all cabling is

properly shielded.

• Please contact ONICON for further assistance.

1 2 ... 13 14 15 16 17 18 19 20

Nessun commento

Onicon F-5200 Inline Manuale Utente Pagina 18